Items Needed To Grow Magic Mushrooms
- Any Opaque Plastic Storage Container With A Lid ( 56+ Quarts)
- 70% Alcohol Spray Bottle
- Water Spray Bottle
- Sterilized Grain Bag And Spore Injection
- Polyfill
- 1.5 inch hole driller
- Coco Coir Substrate Or Any Bulk Substrate you favor (You Can Mix Them)
- Rubber Gloves
- A Room Or Closet With Low Air Flow
- Tape
You Can Buy Them Online (Find A Trusted Source)
STEP 1: Grain Spawning
Before you begin on the way to grow magic mushrooms, sterilize every working part you'll with the 70% spray bottle, even your plastic gloves, and grain bag. Remember to wash with alcohol after every step.
After purchasing your grain and your spawn injection, confirm to wash the tip of the needle with the hearth trick(10 Seconds) and a fast swipe with alcohol tissue.
1: Inject into the bag (Located Near rock bottom Usually With Black Injection Part) and counting on your grain size, squirt about .5ML – 1ML in each corner if you'll towards rock bottom .
2: Place during a dark room and await colonizing
3: As you see, about 20% from rock bottom colonized with white mycelium, you'll spread it around within the bag to form the method grow more evenly and rapidly. (Remember To Sterilize Everything Again)
4: Wait until 100% colonized with mycelium, and you're able to place it into your DIY monotub.
Step 2: Preparing your monotub
1: Drill a 1.5-inch hole about 2-3 inches down from the highest of the container. Two holes on each long side and one each on the smaller side
2: Stuff the holes with polyfill and tape the sides therefore the polyfill won't fall out
3: I can't sweat this enough, Sterilize the bathtub another time even the polyfill. Don’t forget your gloves and lid! (Sterilizing it with alcohol will keep it from getting it contaminated)
4: Layer the colonized grains round the tub and canopy with the substrate you favor . i'm using the Coco Coir. Layer another small batch of grains across the substrate and blend a touch . Spray about 1-2 triggers of water and repeat until you're about 4-5 inches from rock bottom . Leave some grains at the highest . i prefer to layer and blend little or no than mixing all at once rapidly to stop contamination.
5: you'd want your substrate/grains to be kind of moist enough where you'll squeeze a couple of drips out. If not then you'll spray the substrate with slightly with more water
6: Cover the container with the lid and await more mycelium to surface
7: Wait until more mycelium everywhere the highest you're getting to cover the mycelium with more substrate AKA Coco Coir. Spray more water until the substrate is moist (Try to stay an equivalent Humidity)
Step 3: Grow Magic Mushrooms
1: After step 7 of part 2, you'll got to keep the lid slightly open and to spray round the tub and surface 1-2 times each day to stay the moisture
2: await those beautiful magic mushrooms to grow
Step 4: Harvest And Dry
The title says it all! There are some ways to reap and dry that you simply can find online, so I won’t be explaining how to! Relatively smooth. We hope you grow the simplest magic mushrooms with the foremost significant yields! Remember, i'm not an expert; I did it once to find out and researched the foremost I could. Any extra advice you'll give please comment down below
Humidity system for managing moisture in your tub
Something to see your humidity in your tub.
Thank you for tuning in with our special growing Magic mushroom blog, and that we hope you enjoy it! Stay trippy and safe! We advise you to be safe when assuming any psychedelics and remember they're mighty strong.
No comments:
Post a Comment